发票说明：本店标价，都是不包括税点；开票另加税点，详细咨询客服！

注：关于本产品标题，由于商品标题搜索功能的特性，为方便采购方的购物搜索，所起标题关键词仅适用于搜索功能，不涉及广告宣传和功能描述。

温馨提示：由于现货市场浮动较大，店铺所有规格均为参考价格，具体报价请咨询客服，谢谢！

彩涂板因其表面有涂层，因此在成形加工时与普通冷轧板和镀锌板有很多不同的地方，针对彩涂板的部分力学性能(如屈服强度、伸长率)和部分涂层

性能(如铅笔硬度、T弯值、冲击功)对加工成形产生影响，对此应给予足够的重视。在后加工时应注意如下几项：

①零件的形状复杂、变形程度较大时，应采用多道次成形。如果一次成形，可能会因为变形量过大破坏涂层的附着力。

②加工时应根据模具形状、变形特点、工艺条件等因素设定合适的间隙，间隙设定时应考虑涂层的厚度。

③加工时产生的切VI断面易发生腐蚀，因此应采取必要的防护措施，如涂防护涂料、嵌橡胶封条等。

④加工时应尽量减少切断面的毛刺，防止毛刺划伤表面。

⑤应尽可能采用工厂预先装配然后再送现场进行安装的施工方式，安装时应采取保护措施防止损坏涂层。

⑥加工时如发现涂层表面破损应及时采用专门用的修补涂料进行修补，防止破损处发生腐蚀。

Because of its coating, with many different places from ordinary cold rolled and galvanized plates, the mechanical properties (such., yield strength, elongation)

and some coating properties (e. g., pencil hardness, T bending value, impact work) on processing and forming.The following items should be paid attention to in

the post-processing: when the

①parts are complex and highly deformed, multiple forms shall be used.If formed once, the adhesion of the coating may be damaged because of

excessive deformation.

②Appropriate clearance shall be set according to the mold shape, deformation characteristics,and process conditions, and the coating thickness shall be

considered during the gap setting.The cut VI section generated during

③processing is prone to corrosion, so we should take necessary protective measures, such as applying protective coating, embedded rubber seal, etc.

④ shall minimize burr of cut surface to prevent burrs from scratching the surface.

⑤ shall be wherever possible by pre-assembly before delivery to site for installation, and protection shall be taken from damaging the coating.

If the coating surface is found damaged during.

⑥ processing, timely use special repair coating to prevent corrosion in the damaged place.